R&S SMB100A User Manual

Instrument Function
R&S
®
SMB100A
228Operating Manual 1407.0806.32 ─ 21
Remote command:
[:SOURce<hw>]:PULM:MODE on page 391
Pulse Period - Pulse Generator
Sets the period of the generated pulse. The period determines the repetition frequency
of the internal signal.
Remote command:
[:SOURce<hw>]:PULM:PERiod on page 392
Pulse Width - Pulse Generator
Sets the width of the generated pulse. The width determines the pulse length. The
pulse width must be at least 20 ns less than the set pulse period.
Remote command:
[:SOURce<hw>]:PULM:WIDTh on page 404
Pulse Delay - Pulse Generator
(External trigger only)
Sets the pulse delay. The pulse delay determines the time that elapses after a trigger
event before pulse modulation starts. The pulse delay is not effective for double pulse
generation.
Remote command:
[:SOURce<hw>]:PULM:DELay on page 390
Double Pulse Width - Pulse Generator
(Double Pulse only)
Sets the width of the second pulse.
Remote command:
[:SOURce<hw>]:PULM:DOUBle:WIDTh on page 391
Double Pulse Delay - Pulse Generator
(Double Pulse only)
Sets the delay from the start of the first pulse to the start of the second pulse.
Remote command:
[:SOURce<hw>]:PULM:DOUBle:DELay on page 391
Trigger Mode - Pulse Generator
Selects the trigger mode for pulse modulation.
Note: An external trigger signal is supplied via the PULSE EXT connector.
"Auto"
The pulse generator signal is generated continuously.
"Single"
The pulse generator signal is triggered by an internal trigger event,
initiated with the "Execute Single Trigger" on page 229.
"Extern Single"
The pulse modulation is triggered by an external trigger event.
Modulation Generator and LF Output

R&S SMB100A Specifications

General

Brand	R&S
Model	SMB100A
Category	Inverter
Language	English