2000/3000-sheet Finishers (D373/D374)
SM 2-65 D062/D063/D065/D066
Installation
2. If the "Exit Tray Full" alerts continue, set the proof auxiliary tray [A] on the proof tray on
the top of the finisher.
3. Make sure that the arms
of the auxiliary tray fit tightly over the ridges of the
proof tray below.
Shift Auxiliary Tray
1. Open and close the front door of the finisher.
This initializes the finisher and moves the shift tray to the standby position.
2. Open the front door again and leave it open.
3. Set the shift auxiliary tray [A] on the shift tray as shown.
4. Close the front door.
This initializes the finisher again and moves the shift tray to the new standby
position with the auxiliary tray installed.
5. After the Z-folding job is finished, remove the tray and store it in the auxiliary tray
storage pocket on the back of the finisher.
6. Open and close the front door to re-initialize the finisher and reset the standby position
of the shift tray.
To Next Page
Loading...
