Service Program Mode Tables
D062/D063/D065/D066 4-20 SM Appendix
001 Operation Setting
Determines whether multiple copy jobs are stopped at regular intervals for: 0)
Stopping and reversing the drum motor to clean the cleaning blade edge, and 1)
creating an ID sensor pattern to correct toner density control.
[0 to 1/1]
0: No
1: Yes
The interval is set with SP2506-002. Use if the drum gets dirty or images get too
pale or too dark during a long job.
002 Time Setting
Selects the interval at which multi-copy jobs are stopped.
[1 to 100/15/1 min.]
2507* ID Sensor Patterning During Job
001 Operation Setting
Determines whether an ID sensor pattern is created during copy jobs.
[0 to 1/0]
0: Off
1: On
002 No. of Copies
Selects the interval (number of copies) between ID sensor patterns when 1 is
selected for SP2507-001
[0 to 10,000/100/1]
2602 PTL Setting (1st /2nd Copy Side)
Turns the PTL off and on. The PTL (Pre-Transfer Lamp) decreases the charge on
the drum to make better separation of the paper from the drum, and prevents
stripper pawl marks on the leading edges of copies.
Note:
The PTL operates only when copying with plain paper or translucent paper. It
⇒
Rev. 12/29/2011
To Next Page
Loading...
