Service Program Mode Tables
D062/D063/D065/D066 4-86 SM Appendix
0: Release for normal operation
1: Prohibit access to machine
Mode Clear Opt. Counter Removal
5120
Do not change. Japan Only
[0 to 2/ 0 / 1]
0: Yes. Normal reset
1: Standby. Resets before job start/after completion
2: No. Normally no reset
Counter Up Timing SSP
5121
Determines whether the optional key counter counts up at paper feed-in or at
paper exit.
[0 to 1/1]
0: Feed count, 1: No feed count
Set F-size Document
5126
Sets the original size that the machine detects for F sizes.
[0 to 2/1]
0: 8hf x 13
1: 8hf x 13qr
2: 8 x 13
Note: hf = 1/2, qr = 1/4
APS OFF Mode
5127
This SP can be used to switch APS (Auto Paper Select) off when a coin lock or
pre-paid key card device is connected to the machine.
[0 to 1/1]
0: On, 1: Off
To Next Page
Loading...
