Ricoh D131 - Page 518

SC700: Peripherals
SM Appendix 2-51 D131/D132/D133
Appendix:
Service Call
Conditions
SC720-57 B
Stack junction gate motor error (D612)
Occurs during operation of the punch unit. The 1st detection failure
issues a jam error, and the 2nd failure issues this SC code.
 Motor harness disconnected, loose, defective
 Motor overload
 Motor defective
SC720-60 B
Booklet stapler motor error 1 (D612)
The front stapler unit saddle-stitch motor does not start operation
within the specified time. The 1st detection failure issues a jam
error, and the 2nd failure issues this SC code.
 Front motor disconnected, defective
 Front motor overloaded due to obstruction
SC720-61 B
Booklet stapler motor error 2 (D611/D612)
The rear stapler unit saddle-stitch motor does not start operation
within the specified time. The 1st detection failure issues a jam
error, and the 2nd failure issues this SC code.
 Rear motor disconnected, defective
Rear motor overloaded due to obstruction
SC720-70 B
Finisher tray 1 (upper tray lift) motor error (D611/D612)
The upper tray paper height sensor does not change its status with
the specified time after the tray raises or lowers. The 1st detection
failure issues a jam error, and the 2nd failure issues this SC code.
 Tray lift motor disconnected, defective
 Upper tray paper height sensor disconnected, defective
 Finisher main board connection to motor loose
 Finisher main board defective