Ricoh D131 - Page 524

SC700: Peripherals
SM Appendix 2-57 D131/D132/D133
Appendix:
Service Call
Conditions
SC722-37 D
Stack Plate Motor Error 3: Rear Motor (D610)
The stack plate HP sensor (rear) does not activate within 500 ms
after the motor turns on. The 1st detection failure causes a jam
error, and the 2nd failure causes this SC code.
If the motor is operating
 Rear stack plate HP sensor harness loose, broken, defective
 Rear stack plate HP sensor defective
If the motor is not operating:
 Motor blocked by an obstruction
 Motor harness loose, broken, defective
 Motor defective
 Booklet finisher main board defective
SC722-39 B
Jogger Top Fence Motor (D610)
The top fence HP sensor detected that:
The top fence did not arrive at the home position within the
specified number of pulses.
-or-
The top fence failed to leave the home position within the specified
number of pulses.
If the jogger top fence motor is operating:
 Top fence HP sensor harness loose, broken, defective
 Top fence HP sensor defective
If the jogger top fence motor is not operating:
 Motor blocked by an obstruction
 Motor harness loose, broken, defective
 Motor defective
 Finisher main board defective