Ricoh D131 - Page 525

SC700: Peripherals
D131/D132/D133 2-58 SM Appendix
SC722-40 B
Jogger Bottom Fence Motor (D610)
The bottom fence HP sensor detected that:
The bottom fence did not arrive at the home position at the
specified time.
-or-
The bottom fence failed to leave the home position at the specified
time.
If the jogger bottom fence motor is operating:
 Bottom fence HP sensor harness loose, broken, defective
 Bottom fence HP sensor defective
If the jogger bottom fence motor is not operating:
 Motor blocked by an obstruction
 Motor harness loose, broken, defective
 Motor defective
 Finisher main board defective
SC722-41 D
Feed-Out Belt Motor Error (D610)
The stack feed-out belt HP sensor does not activate within the
specified time after the stack feed-out belt motor turns on. The 1st
detection failure causes a jam error, and the 2nd failure causes this
SC code.
If the motor is operating
 Stack feed-out HP sensor harness loose, broken, defective
 Stack feed-out HP sensor defective
If the motor is not operating:
 Feed-out motor blocked by an obstruction
 Feed-out motor harness loose, broken, defective
 Feed-out motor defective
 Booklet finisher main board defective