SP1000 Feed
D131/D132/D133 3-12 SM Appendix
1903 Web Job End
1 Yes/No
This determines whether the web motor is driven at the end of a job.
[0 to 1/1]
0: Off
1: On
Enable when too much paper dust is causing copies to blacken.
2 Job End Condition (Continuous PPC Time)
At the end of a job, the web motor is driven if the job lasted longer than the
value of this SP mode. Only valid if SP1903-001 is set to 'On'.
[1 to 99/7/1s]
3 Job End Frequency
If the web motor is driven at the end of a job, this SP determines how many
times the web motor operation is executed.
[1 to 5/2/1]
1904 By-pass Tray Paper Size Correction
1
Minimum Size
Calibrates the minimum paper width position of the sensor (100 mm). Move
the side fences to the 100 mm position then press Execute.
2
Maximum Size
Calibrates the maximum paper width position of the sensor (A3). Move the
side fences to the A3 position then press Execute.
To Next Page
Loading...
