Input/Output Check
D131/D132/D133 3-298 SM Appendix
20 APS Start Sensor Not Start Start
21 Bottom Plate HP Sensor Not HP HP
22 Bottom Plate Posirion Sensor
Not Correct
Position
Correct Position
3.13.4 ADF OUTPUT CHECK: SP6008
1. Open SP mode SP6008.
2. Select the SP number that corresponds to the component you wish to check. (Refer to the
table below.)
3. Press On then press Off to test the selected item. You cannot exit and close this display until
you click Off to switch off the output check currently executing.
6008
ADF Output Check
Turns on the ADF electrical components individually for testing.
1 Feed Motor: Forward
2 Feed Motor: Reverse
3 Transport Motor: Forward
4 Exit Motor: Forward
8 Stamp Solenoid
9 Pick-up Motor: Forward
10 Bottom Plate Motor: Reverse
To Next Page
Loading...
