Main SP Tables-2-1
D146/D147/D148/D149/D150 2-172 System Maintenance Section
2103
[Erase Margin Adjustment]
Sets trim for duplex.
006 Duplex Trail. L Size *ENG [0.0 to 4.0 / 1.0 / 0.1mm/step]
007 Duplex Trail. M Size *ENG [0.0 to 4.0 / 0.8 / 0.1mm/step]
008 Duplex Trail. S Size *ENG [0.0 to 4.0 / 0.6 / 0.1mm/step]
009 Duplex Left Edge *ENG [0.0 to 1.5 / 0.3 / 0.1mm/step]
010 Duplex Right Edge *ENG [0.0 to 1.5 / 0.3 / 0.1mm/step]
011 Duplex Trail. L Size:Thick *ENG [0.0 to 4.0 / 1.0 / 0.1mm/step]
012 Duplex Trail. M Size:Thick *ENG [0.0 to 4.0 / 0.8 / 0.1mm/step]
013 Duplex Trail. S Size:Thick *ENG [0.0 to 4.0 / 0.6 / 0.1mm/step]
014 Duplex Left Edge:Thick *ENG [0.0 to 1.5 / 0.3 / 0.1mm/step]
015 Duplex Right Edge:Thick *ENG [0.0 to 1.5 / 0.3 / 0.1mm/step]
2106
[Polygon Rotation Time]
Sets pre-rotating time/ post-rotating time for polygon motor.
001
Warming-Up *ENG [0 to 60 / 10 / 1sec/step]
Sets pre-rotating time for polygon motor. With touching the operating during
standby, polygon motor will pre-rotate.
With this, waiting time will be shorter.
002
Job End *ENG [0.0 to 60.0 / 0.1 / 0.1sec/step]
Sets post-rotating time for polygon motor. Polygon motor will post-rotate after
printing. If a print order come during post-rotation, printing will start faster.
To Next Page
Loading...
