Main SP Tables-2-1
D146/D147/D148/D149/D150 2-186 System Maintenance Section
004 Standard Speed: Ye *ENG [50 to 120 / 100 / 1%/step]
005 Middle Speed: Bk *ENG [50 to 120 / 100 / 1%/step]
006 Middle Speed: Ma *ENG [50 to 120 / 100 / 1%/step]
007 Middle Speed: Cy *ENG [50 to 120 / 100 / 1%/step]
008 Middle Speed: Ye *ENG [50 to 120 / 100 / 1%/step]
009 Low Speed: Bk *ENG [50 to 120 / 100 / 1%/step]
010 Low Speed: Ma *ENG [50 to 120 / 100 / 1%/step]
011 Low Speed: Cy *ENG [50 to 120 / 100 / 1%/step]
012 Low Speed: Ye *ENG [50 to 120 / 100 / 1%/step]
2154
[Shad. Correct Setting]
Changes exposure light amount form each beam.
§ Value increase: Light amount increases, and image density gets deeper.
§ Value decrease: Light amount decreases, and image density gets thinner.
Except, if Process control is executed, light amount / density will change.
Beam interval light amount: No need to operate.
002 Front End Area: Bk: LD1 *ENG [50.0 to 150.0 / 100.0 / 0.1%/step]
003 Front End Area: Bk: LD2 *ENG [50.0 to 150.0 / 100.0 / 0.1%/step]
004 Front End Area: Bk: LD3 *ENG [50.0 to 150.0 / 100.0 / 0.1%/step]
005 Front End Area: Bk: LD4 *ENG [50.0 to 150.0 / 100.0 / 0.1%/step]
007 Front End Area: Ma: LD1 *ENG [50.0 to 150.0 / 100.0 / 0.1%/step]
008 Front End Area: Ma: LD2 *ENG [50.0 to 150.0 / 100.0 / 0.1%/step]
009 Front End Area: Ma: LD3 *ENG [50.0 to 150.0 / 100.0 / 0.1%/step]
010 Front End Area: Ma: LD4 *ENG [50.0 to 150.0 / 100.0 / 0.1%/step]
012 Front End Area: Cy: LD1 *ENG [50.0 to 150.0 / 100.0 / 0.1%/step]
013 Front End Area: Cy: LD2 *ENG [50.0 to 150.0 / 100.0 / 0.1%/step]
014 Front End Area: Cy: LD3 *ENG [50.0 to 150.0 / 100.0 / 0.1%/step]
To Next Page
Loading...
