B245/B276/B277/B268/B269 Service Manual 18-Jan-06
142
Paper Feed Timing
1003*
Adjusts the amount of buckle the paper feed clutch applies to the paper after the
registration sensor is activated. A higher setting applies greater buckling.
1003 1 1st tray
[0 ~ 10 / 5 / 1 mm/step]
1003 2 2nd tray (B276/B277 only)
[0 ~ 10 / 5 / 1 mm/step]
1003 3 Optional tray
[0 ~ 10 / 5 / 1 mm/step]
1003 4 By-pass feed
[0 ~ 10 / 6 / 1 mm/step]
1003 5 Duplex
[0 ~ 20 / 6 / 1 mm/step]
1007
Display By-pass
1007 1 Display By-pass Displays the by-pass paper width switch output.
Fusing Idling
1103*
This program decides the action of the Fusing Drive Release Mechanism. When
you select "1," the contact/release control is disabled and the drive power is
always transmitted to the fusing unit. As a result, the machine takes a longer
time to warm up the fusing unit. Use SP 1103 1 if fusing quality is low even when
the room temperature is not very low.
1103 1 Fusing Idling
[0 = No / 1 = Yes]
Fusing Temperature Adjustment
1105*
Adjusts the target fusing temperature. "Center" indicates the center of the roller;
"End" indicates the front and rear ends.
1105 1 Warm Up-Center
1105 2 Warm Up-End
[140 ~ 180 / 160 / 1°C/step]
1105 3 Standby-Center
[140 ~ 170 / 155 / 1°C/step]
1105 4 Standby-End
[140 ~ 165 / 150 / 1°C/step]
1105 5 Copying-Center
1105 6 Copying-End
[140 ~ 185 / 160 / 1°C/step]
1105 7 Low Level 2-Center
1105 8 Low Level 2-End
[0 ~ 80 / 60 / 1°C/step]
1105 9 Thick-Center
1105 10 Thick-End
[140 ~ 185 / 175 / 1°C/step]
1105 11 Warm Up Low-Center
[140 ~ 180 / 170 / 1°C/step]
To Next Page
Loading...
