Risco ProSYS Plus - Bus Zone: Iwise DT Grade 2

11
/
2017 Page 119 5IN2413 B
Bus Zone: iWISE DT Grade 2
Quick Keys Parameter Default Range
 ZZZ 
LEDS
On
Defines the LEDS operation mode.
 OFF - Disables the LEDS operation.
 ON – Enables the LEDS operation.
 ZZZ 
MW (Microwave)
Range
Trimmer
Defines the microwave channel range.
MINIMUM 25% 50% 65%  85%  MAXIMUM 
TRIMMER (MW is defined by the trimmer setting on the PCB)
 ZZZ 
ACT
No
Defines the Anti-Cloak™ Technology (ACT) operation mode.
 NO – Disables the ACT mode
 YES – Enables the ACT mode
 ZZZ 
Automatic
Microwave Bypass
No
Defines whether the microwave (MW) channel will be bypassed or
not while the detector identifies trouble in the MW channel.
 NO - While detecting a problem in the MW channel it is not
bypassed. Alarm condition cannot be established until the MW
channel is fixed.
 YES - Switches the detector to operate only in PIR mode in case of
MW trouble
 ZZZ 
Green Line
Yes
A feature that follows environmental guidelines by avoiding surplus
emission This feature defines the activation of the microwave channel
while the system is disarmed.
 NO - Green Line feature is disabled. MW is constantly activated.
 YES - Green Line feature is activated.
 ZZZ 
Self Test
Remote
Used to test the detection technologies. In the event of a failed test, a
self-test trouble is created.
 REMOTE (Manual) - The remote self-test is performed by the
system when a user manually selects the Diagnostics option from the
Maintenance menu via the ProSYS Plus User Functions menu
 LOCAL (automatic) - Once an hour, the detector automatically
checks that the detector’s channels are functioning properly.