11
2017 Page 22 5IN2413 B
Installation
Main Tasks for Initial System Setup
Installing and setting up the system should be performed by a professional alarm
system installer. Presented here is a typical order of performing these tasks:
System Installation
Step 1: Creating a Plan for Mounting the System
Step 2: Wiring, Settings, and Module Installations at the Main Panel
Step 3: Bus Line Installations
Step 4: Connecting Relay Detectors
Step 5: Connecting the Backup Battery and Mounting the Main Panel
System Initialization, Device Allocation & General Configuration
Step 1: Describing Keypad Controls and Installer Menus
Step 2: Powering-Up and Initializing the System
Step 3: Allocating and Configuring Installed Components
Step 4: Allocating Wireless Zones
Step 5: Basic Zone Configuration for All Zone Types
Step 6: Advanced Zone Configuration for Bus Zones and Wireless Zones
Step 7: Configuring System Communication
Step 8: Configuring Cloud Connectivity
Step 9: Configuring Common System Parameters
Installer Programming
• Defining Parameters – Installer Programming Menu
• Exiting Installer Programming Menu after Initial System Programming
• Defining Parameters – Additional Installer Menus
System Testing
Various system tests are available for the ProSYS Plus. Relevant tests should be
performed for verifying system operability during initial system setup, as well as
after completion of the initial system setup (before system handover to the client).
Tests are also available for system diagnostics. See Testing the System, page 215.
Installer Responsibilities in Assisting the Client
Upon handing over a fully configured and fully tested system to the client, a
checklist is provided listing some of the main areas that the installer should assist
the client with. See Installer Responsibilities for Assisting the Client, page 216.
To Next Page
Loading...
