Risco ProSYS Plus - Code Length; Installer; Sub Installer

11
/
2017 Page 149 5IN2413 B
 Installer
Codes  Installer
Default = 1111. The Installer code provides access to the installer Programming
menu as well as all other installer menus, allowing modification of system
parameters. The installer can change the installer code.
 Sub Installer
Codes  Sub-installer
Default = 2222. The sub-installer code allows limited access to selected installer
programming parameters. It is recommended to change the code to one that is
unique.
The sub-installer is prohibited from accessing the following parameters:
• Default enable (to change the panel back to default factory settings)
• Code length
• Installer code
• Communication menu
• Customer ID
• Standards
 Code Length
Codes  Code Length
The installer, sub-installer, and Grand Master can define the number of digits. The installer
designates the codes to be either 4 or 6 digits in length. If defined as 6 digits, the length
apply for everybody - all users/installers, however if defined as 4 digits, Grand Master,
Installer, and Sub-Installer must have 4-digit codes, while the system users can codes of
various lengths, from 1—4 digits.
Notes
• When you change the code length parameter, all user codes are deleted and must be re-
programmed or downloaded.
• For a 6-digit code length system, 4-digit default codes like 1-2-3-4 (Grand Master),
1-1-1-1 (Installer), and 2-2-2-2 (Sub-Installer) become 1-2-3-4-0-0, 1-1-1-1-0-0, and
2-2-2-2-0-0, respectively.
• If you change the code length back to 4 digits, the system codes are restored to the
default 4-digit codes.
EN 50131 Notes
 All code length are 6 digits: xxxxxx
 For each digit 0-9 can be used
 All codes from 000001 to 999999 are acceptable
 Invalid codes cannot be created since after 6 digits are input, the "Enter" is automatic.
 Codes are rejected when trying to create a code in the wrong format.