Risco ProSYS Plus - Step 6: Advanced Zone Configuration for Bus Zones and Wireless Zones; Advanced Programming for Wireless Zones

11
/
2017 Page 68 5IN2413 B
Step 6: Advanced Zone Configuration for Bus Zones
and Wireless Zones
NOTE: To set additional parameters, see Installer Programming, page 77.
Advanced Programming for Bus Zones
 Configuring advanced parameters for bus zones:
1. At the installer Programming menu, go to: 21274 (Zones
ParametersBy CategoryAdvanced BZ Parameters), then press OK ().
2. Scroll to the bus zone number to program, and then press OK.
3. Scroll through the options and configure the relevant parameters for the zone,
pressing OK after each to confirm.
Advanced Programming for Wireless Zones
 Configuring advanced parameters for wireless zones:
1. At the installer Programming menu, go to: 21275 (Zones 
ParametersBy CategoryAdvancedWL Parameters), then press OK ().
2. Enter the wireless zone number to program, and then press OK.
3. Scroll through and configure the relevant parameters for the zone, pressing OK
after each to confirm.