Risco ProSYS Plus - Bus Zone: Watchin DT Grade 3

11
/
2017 Page 124 5IN2413 B
Bus Zone: WatchIN DT Grade 3
Quick Keys Parameter Default Range
 ZZZ 
LEDS
3 LEDS
Defines the LEDS operation mode.
 OFF - Disables the LEDS operation.
 RED ONLY - Only the Red LED will operate. This option is highly
recommended to avoid the possibility that a burglar will “Learn” the
detector behavior.
 3 LEDS - All 3 LEDs will operate.
 ZZZ 
Detection
Sensitivity
Normal
Defines the sensitivity of the detector (MW + PIR).
LOW MEDIUM NORMAL  ACT (Anti-Cloak™ Technology)
 ZZZ 
MW (Microwave)
Range
Trimmer
Defines the microwave channel range.
 MINIMUM  25%  50%  65%  85%  MAXIMUM
 TRIMMER
(MW is defined by the trimmer setting on the PCB)
 ZZZ 
Alarm Logic
PIR and Microwave
Determine the detector’s logic of defining an alarm.
 PIR & MW (and Microwave) – An alarm is activated when both PIR
and MW channels detect an alarm (AND Logic).
 PIR / MW (or Microwave) - An alarm is activated when either PIR
or MW channels detect an alarm (OR Logic).
 ZZZ 
Lens Type
Wide Angle
Defines the actual lens of the detector.
 WIDE ANGLE
 BARRIER / LONG RANGE
 ZZZ 
Anti-Mask
Enable
Defines the operation of anti-masking detection.
 DISABLE
 ENABLE