11
2017 Page 77 5IN2413 B
Installer Programming
ProSYS Plus can be programmed by the installer using the following:
• Wired keypad
• Configuration Software (locally or remotely connected – see the CS
documentation).
When performing installer programming in the various installer menus, some of
the parameters display dynamically, meaning that the keypad will only display the
parameters for the respective modules/hardware that are installed.
IMPORTANT: After finishing to work in the installer Programming menu the first
time (for initially programming the system), you must then exit the menu. See
Exiting Installer Programming Menu after Initial System Programming, page 208.
Defining Parameters – Installer Programming Menu
This section describes all parameters contained in the installer Programming menu,
including the common definitions described prior in this manual.
The installer Programming menu consists of the following sub-menus:
System
Zones
Outputs
Codes
Communication
Audio
Install
Devices
Exit
To Next Page
Loading...
