Risco ProSYS Plus - Macro Menu; Stand Alone Keyfob Menu

11
/
2017 Page 214 5IN2413 B
Maintenance parameters
 Signal (RSSI) – Displays the signal level measured by the GSM module (0 = no signal,
5 = very high signal)
 Version – Displays information regarding the GSM module version
 IMEI – Displays the IMEI number of the GSM module. This number is used for
identification of the ProSYS Plus at the RISCO IP Receiver when using GSM or GPRS
communication
• IP Module – Performs a diagnostic test for the following parameters of the plug in
IP or IP module:
 IP Address – View the system's IP address
 Version – View the IP module's software version/date
 MAC Address – View the MAC address of the IP card. This number is used for
identification of the system at the RISCO IP Receiver when using the IP
communication module.
• WM Version – Displays the selected wireless expansion module's software version/date
• Panel Version – Displays the main panel (system) software version/date
• Voice Version – Displays the voice module's software version/date
• Keypad Version – Displays the selected keypad's software version/date
• LRT – Displays the LRT module software version and its active protocol
• SEM Version – Displays the SEM version/date
Macro Menu
Macro parameters
Test a selected macro, if it has been pre-programmed. Scroll to select the respective macro
(A—D), and then press OK. For more information on programming macros, see the
ProSYS Plus User Manual..
Stand Alone Keyfob Menu
Stand Alone Keyfob parameters
Standalone keyfobs are used for gate control (with a dedicated wireless expander module).
Scroll to select the wireless expander module used for the standalone keyfobs/gate control,
and then press OK. For the respective keyfobs supported, select from the following
parameters to configure. For more information on standalone keyfobs, see the ProSYS Plus
User Manual.
• New Keyfob – To allocate a new keyfob
• Delete Keyfob – To delete the allocation of a keyfob
• Delete All – To delete all keyfob allocations (the keyfobs using the dedicated
wireless expansion module for gate control only)
• UO Buttons – To change the keyfob buttons that control utility outputs