Risco ProSYS Plus - Describing Installer-Set ID Numbers for Bus Devices

11
/
2017 Page 38 5IN2413 B
Describing Installer-Set ID Numbers for Bus Devices
For each bus device category (see the table below), each of its respective bus
devices gets a sequentially-assigned, installer-set “physical” ID number that the
installer physically sets with the device’s DIP switches before powering up the
device.
NOTE: To be unique, bus devices in the same category that are on the same bus
line must have sequentially different physical ID numbers, whereas different
devices (or the same bus device types on different bus lines) can have the same
physical ID number.
Categories Respective Bus Devices
ZONES
Bus Zone Expanders
Bus zones (bus detectors)
Zone expansion modules: single-zone expander, 8-zone expander,
16-zone expander
Wireless expander
OUTPUTS Output expansion modules: 4 outputs/3A, 8 outputs/100 mA
POWER SUPPLY
UNITS
Power supply expansion modules: 1.5A, 3A
WIRED
KEYPADS
Elegant, LCD, etc.
BUS SOUNDERS ProSound, Lumin8
KEY READERS Proximity Key Reader