Risco ProSYS Plus - Bus Zone: ODT15 (Watchout DT)

11
/
2017 Page 123 5IN2413 B
Bus Zone: ODT15 (WatchOUT DT)
Quick Keys Parameter Default Range
 ZZZ 
LEDS
3 LEDS
Defines the LEDS operation mode.
 OFF - Disables the LEDS operation.
 RED ONLY - Only the Red LED will operate. This option is
highly recommended to avoid the possibility that a burglar will
“Learn” the detector behavior.
 3 LEDS - All 3 LEDs will operate.
 ZZZ 
PIR Sensitivity
Normal
Defines the PIR sensitivity of the detector.
 LOW  MEDIUM  NORMAL  HIGH
 ZZZ 
Microwave Range
Trimmer
Defines the microwave channel range.
 MINIMUM  20%  40%  60%  80%  MAXIMUM
 TRIMMER
(MW is defined by the trimmer setting on the PCB)
 ZZZ 
Anti Mask
Sensitivity
Defines the sensitivity of the active IR AM:  LOW  HIGH
 ZZZ 
Lens Type
Wide Angle
Defines the actual lens of the detector.
 WIDE ANGLE  BARRIER / LONG RANGE
 ZZZ 
Anti-Mask
Enable
Defines the operation of anti-masking detection.
 DISABLE Enable
 ZZZ 
Arm/Disarm
No
Defines the operation of the LEDs and anti-masking detections while
the detector is armed.
 Active IR AM and Proximity AM (anti-masking) is enabled.
LEDs behave according to the LEDs parameter definition.
 YES – Active IR AM and Proximity AM (anti-masking) is
disabled LEDs are disabled.
 ZZZ 
Prox Anti-mask
Enable
Defines the operation of proximity anti-masking detection.
 DISABLE  ENABLE