11
2017 Page 76 5IN2413 B
Defining Follow Me Parameters
To define parameters for a Follow Me destination:
1. From the installer Programming menu go to: 5)Communication menu
4)Follow Me 1)Define FM); Follow Me 01 displays (1st FM destination).
2. Scroll to a FM number to define, and then press OK ( ).
3. Scroll through the following options and define them as needed: Report Type,
Partition, Events, Restore Events, Remote Control.
Defining System Timers
To define system timers:
1. From the installer Programming menu, select 1)System 1)Timers
2. Scroll to select from the options and modify their parameters as needed.
Defining All Additional Parameters
For defining all additional system parameters in the installer Programming menu,
as well as in other installer menus, see the next section (Installer Programming).
IMPORTANT:
• After you have finished programming all relevant parameters in the installer
Programming menu at the time of initial system setup, you must then
perform the procedure to exit the installer Programming mode. See Exiting
Installer Programming Menu after Initial System Programming, page 208.
• For accessing the installer Programming menu again after initial system setup
(after you have performed the procedure to exit installer Programming mode),
see Subsequently Accessing & Exiting Installer Programming Menu, page 209.
• To restore the system’s factory defaults, see Restoring Manufacturer's
Programming Defaults, page 209.
To Next Page
Loading...
