11
2017 Page 240 5IN2413 B
Appendix G: Remote Software Upgrade
This appendix explains how to perform remote upgrade of your ProSYS Plus main
panel software using the ProSYS Plus keypad or SMS command. Remote software
upgrade is performed via IP or GPRS.
Notes
1. It is recommended to perform the upgrade process from keypad 1 (not from a wireless
keypad).
2. Software upgrade does not delete all previous parameters of the panel.
Step 1: Set parameters for IP/GPRS communication
Define all parameters required to set GPRS or IP communication as explained in
the Communication section of the ProSYS Plus (See page 150).
Step 2: Enter the location of the firmware update file
• Go to: 1 8 (installer Programming menu System Firmware Update),
and enter the relevant information regarding the location of the F/W update
file:
Server IP: Enter the IP address of the router/gateway where the F/W update
file is located. Default: firmware.riscogroup.com
Port: Enter the port on the router/gateway where the F/W update file is
located. Default: 00080
File Name: Enter the F/W update file name. Default: CMD.TXT
Notes
1. The file name is case sensitive.
2. Please contact RISCO Group Customer Support services for the file name parameters.
Step 3: Activate the Remote Upgrade from the keypad
1. Go to: 1 8 4 (installer Programming menu System Firmware Update
Download File).
2. Select the communication path as follows:
Via IP
Via GPRS
To Next Page
Loading...
