Risco ProSYS Plus - Power Supply Modules; Proximity Key Readers; Wireless Expanders

11
/
2017 Page 59 5IN2413 B
Power Supply Modules
1. From the installer Programming menu, select 7 1 2, scroll to
04)Power Supply, and then press OK ( ).
2. Scroll to, and then edit the power supply module’s physical ID number to
match its DIP switch settings (see Describing Installer-Set ID Numbers for Bus
Devices, page 38).
3. Toggle to the PS type (or select NONE to cancel its allocation), and then press
OK.
4. Select the partition number(s) for the power supply module. While scrolling
through each block of partitions, designate the partition(s) to allow operation
via the keypad. Enter a partition number to select it (it will display), or enter the
number again to clear it (it will not display).
5. Press OK; 1)BELL/L.SPEAK N displays
6. Toggle between Y (yes) or N (no) for enabling or disabling the bell /
loudspeaker, and then press OK.
7. Repeat from step 2 for all additional power supply modules.
Wireless Expanders
1. From the installer Programming menu, select 7 1 2, scroll to
05)WL Expander, and then press OK ().
2. Scroll to, and then edit the WL expander’s physical ID number to match its DIP
switch settings (see Describing Installer-Set ID Numbers for Bus Devices, page 38).
3. Toggle to WM (wireless module), or select NONE to cancel its allocation, and
then press OK.
4. Toggle to Y or N for bypassing the box tamper, then press OK.
Proximity Key Readers
1. From the installer Programming menu, select 71 2, scroll to
06)Prox Key Rd, and then press OK ( ).
2. Scroll to, and then edit the physical ID number of the PKR (Proximity Key
Reader) to match its DIP switch settings (see Describing Installer-Set ID Numbers
for Bus Devices, page 38).
3. Toggle to PRK or select NONE to cancel its allocation, and then press OK; the
Mask screen displays where you can enable operability of specific partition(s)
when using this PKR.