Risco ProSYS Plus - Step 7: Configuring System Communication; Defining Primary Communication Channels & Parameters

11
/
2017 Page 71 5IN2413 B
Step 7: Configuring System Communication
NOTE: To set additional parameters, see Installer Programming, page 77.
Defining Primary Communication Channels & Parameters
 To define the primary communication channel:
1. From installer Programming menu go to: 5) Communication menu1) Method
2. Scroll to the primary communication channel: (GSM, PSTN, IP), then press OK.
3. Scroll through the respective parameters (see the table below), and define the
relevant ones, pressing OK after each parameter that is set.
NOTES:
• You can connect to the Cloud and additional destinations/monitoring station in
parallel, using a single multi-socket communication module (IP, GSM 2G or
GSM 3G), or by using 2 single-socket communication modules
• For setting the backup communication channel to the monitoring station, see
Defining Monitoring Station Account Parameters, page 72.
• ProSYS Plus menus reflect only the communication modules that are installed.
• For IP communication, you can set it to Dynamic IP or Static IP. See Setting
Dynamic IP / Static IP, page 56.
• To establish GPRS communication, a SIM card must be installed.
Primary
Comm.
Channel
Parameters
PSTN
1) Timers  1)PSTN Lost, 2)Wait Dial Tone
2) Control  1)Alarm PH CUT (Y/N), 2)Answering machine (Y/N)
3) Parameters  1)Dial Method [DTMF
, Pulse 20 BPF, Pulse 10 bps],
2)Rings To Answer, 3)Area Code, 4)PBX Prefix, 5)Call Waiting
GSM
1) Timers  1)GSM Lost, 2)GSM Net Loss, 3)SIM Expire, 4)MS Polling
[Primary, Secondary, Backup]
2) GPRS  1)APN Code, 2)APN User Name, 3) APN Password
3) Email  1)Mail Host, 2)SMPT Port, 3)Email Address, 4)SMPT UserName,
5)SMPT Password
4) Controls  1)Caller ID (Y/N)
5) Parameters  1)PIN Code, 2)SIM Number, 3)SMS Centre PH, 4) GSM RSSI
[Disable, Low signal, High signal]
6) Prepay SIM  1)Get Credit By [Credit SMS, Credit Voice, Service Cmnd],
2)PN To Send, 3)PN to Receive, 4)SMS Message
IP
1) IP Config  1)Obtain IP [Dynamic IP, Static IP], 2)Panel Port
2) E-mail [Mail Host, SMTP Port, Email Address, SMTP Name, SMTP Password],
3) Host Name [Security_System]
4) MS Polling [Primary, Secondary, Backup]