11
2017 Page 64 5IN2413 B
5. Repeat from step 3 for each additional wireless transmitting device to be
allocated for this wireless expander.
6. After you have allocated the devices for this specific wireless expander, repeat
the procedure from step 2 for all additional wireless expanders (and then their
respective transmitting devices).
7. Now define the basic parameters for the wireless zones, such as labels,
partitions, etc. (see Step 5: Basic Zone Configuration for All Zone Types, page 65).
8. After, it may be beneficial to perform advanced programming such as
measuring and setting the background noise threshold level, followed by
performing a wireless communication test (see Advanced Programming for
Wireless Zones, page 68).
Allocating Wireless Devices via Code
To allocate a wireless device via the device’s code:
1. From the installer Programming menu, go to 7 2 2 2 (Install
WL Device Allocation By code)
2. Scroll to the zone or wireless device type [keyfob, keypad, sounder]).
NOTE: See table above for specific wireless device types.
3. If you have multiple wireless receivers scroll to the first one for which you wish
to allocate it’s respective wireless devices.
4. Press OK ( ); Each zone/device appears in one of the following formats:
“Select (—:———:——)” which indicates it is available for allocating, or
“Select (3:E02:06)” which, in this example, indicates it has already been
allocated.
NOTE: If you try to allocate the same wireless zone number/device twice, the
second allocation will over-write the prior allocation
5. Scroll to the zone number/device you want to allocate (or enter the zone number
using 3 digits – for example enter 022 for zone 22), and then press OK;
Z=xxx (RE) WRITE: 00000000000 displays (whereas xxx = the zone number). For
devices, the device name, number and (RE) WRITE: 00000000000 display.
6. Enter the 11-digit code of the wireless device to enroll, and then press OK; the
zone number and device description appears if successfully allocated.
To Next Page
Loading...
