Risco ProSYS Plus - Bus Zone: (Industrial) Lunar;Bware;Iwise DT Grade 3

11
/
2017 Page 120 5IN2413 B
Bus Zone: (Industrial) Lunar /BWare/iWISE DT Grade 3
Quick Keys Parameter Default Range
 ZZZ 
LEDS
On
Defines the LEDS operation mode.
 OFF - Disables the LEDS operation.
 ON – Enables the LEDS operation.
 ZZZ 
MW (Microwave)
Range
Trimmer
Defines the microwave (MW) channel range.
 MINIMUM 25% 50% 65% 85% MAXIMUM
TRIMMER (MW is defined by the trimmer setting on the PCB)
 ZZZ 
ACT
No
Defines the Anti-Cloak™ Technology (ACT) operation mode..
 NO – Disables the ACT mode
 YES – Enables the ACT mode
 ZZZ 
Automatic
Microwave Bypass
No
Defines whether the microwave channel will be bypassed or not while
the detector identifies trouble in the MW channel.
 NO - While detecting a problem in the MW channel it is not
bypassed. Alarm condition cannot be established until the MW
channel is fixed.
 YES - Switches the detector to operate only in PIR mode in case of
MW trouble
 ZZZ 
Green Line
Yes
A feature that follows environmental guidelines by avoiding surplus
emission This feature defines the activation of the microwave channel
while the system is disarmed.
 NO - Green Line feature is disabled. MW is constantly activated.
 YES - Green Line feature is activated.
 ZZZ 
Anti-Mask
Enable
Defines the operation of anti-masking detection.
 DISABLE
 ENABLE and behaves according to the settings defined in quick
keys ZZZ