Risco ProSYS Plus - Subsequently Accessing & Exiting Installer Programming Menu; Restoring Manufacturers Programming Defaults

11
/
2017 Page 209 5IN2413 B
Subsequently Accessing & Exiting Installer Programming Menu
When you've finished programming in installer Programming menu at initial
system setup and have already performed the procedure to exit the installer
Programming menu, in order to access this menu again—or any other installer
menus, make sure that DIP switch 2 remains in the OFF position – otherwise
installer, sub-installer and Grand Master codes will reset to factory defaults.
When you finish subsequent programming, leave the DIP switch 2 in the OFF
position.
NOTE: To again program parameters found in the installer Programming menu,
another option is to do so from the Configuration Software.
Restoring Manufacturer's Programming Defaults
You can revert to manufacture defaults for all system parameters.
 To restore the main panel to the manufacturer's defaults:
1. From the installer Programming menu, select 1
 5 2 (SystemSetting
Default Panel).
2. To restore the system labels to the manufacturer defaults (delete all labels),
toggle to Y (yes) and then press OK () to confirm.
3. To revert to the default panel and keep existing labels, toggle to N, and then
press OK.
NOTE: It may take a minute or two to process, but wait until
SETTINGS: 2) DEFAULT PANEL displays.
4. To save your settings exit the Programming mode.