11
2017 Page 55 5IN2413 B
Manually Allocating & Configuring Communication Modules
If you didn’t yet run an Auto-Setting scan to allocate (“enable”) each installed
communication module, you can do so manually from the installer Programming
menu, as well as configure its relevant parameters.
IMPORTANT: If an allocated communication module is no longer to be utilized,
you must disable it (cancel its prior allocation) via this manual process. After
cancelling, if needed, you can then re-write over it in order to newly allocate
another communication module.
NOTE: To set additional parameters, see Installer Programming, page 77.
NOTE: After manually programming communication modules, you can perform a
bus test (see Performing a Bus Test, page 54).
GSM Modules
1. From the installer Programming menu select 7 1 2, scroll to 10) GSM, and
then press OK ().
2. Toggle to the type of GSM module installed (or select NONE to cancel its
allocation), and then press OK.
Entering or Deleting a SIM Card PIN
If your SIM card required a PIN (personal ID number) you will need to enter it. If
not, you will need to disable it.
To enter or delete a SIM card PIN:
1. From the installer Programming menu select 5 1 2 5 1, enter the PIN,
and then press OK ().
-OR-
2. If a PIN is not needed, you can choose to disable it by inserting the SIM card in a
cell phone and disabling the code.
3. You can manually define APN definitions if you don’t have them configured
automatically (default), see Defining APN Automatically and Manually, page 56.
NOTE: It is recommended to test the operation of a SIM card by conducting a
call and testing the GSM signal strength. See Testing the System, page 215.
To Next Page
Loading...
