Risco ProSYS Plus - Bus Zone: OPR12 (Watchout PIR)

11
/
2017 Page 118 5IN2413 B
Bus Zone: OPR12 (WatchOUT PIR)
Quick keys Parameter Default Range
ZZZ
LEDS
3 LEDS
Defines the LEDS operation mode.
 OFF - Disables the LEDS operation.
 RED ONLY - Only the Red LED will operate. This option is highly
recommended to avoid the possibility that a burglar will “learn” the
detector behavior.
3 LEDS - All 3 LEDs will operate..
 ZZZ 
PIR Sensitivity
Normal
Defines the PIR sensitivity of the detector.
 LOW  MEDIUM  NORMAL  HIGH
 ZZZ 
Lens Type
Wide Angle
Defines the actual lens of the detector.
 WIDE ANGLE  BARRIER / LONG RANGE
 ZZZ 
Auxiliary
Relay Mode
Off
Defines the operation of the auxiliary relay of the detector.
 OFF - Auxiliary relay is disabled
 24 Hours - The auxiliary relay will always follow an alarm
 NIGHT ONLY - The auxiliary relay output will follow an alarm
condition only during night time.
 ZZZ 
Auxiliary Relay
Time
2.2 Seconds
2.2—480 seconds
Defines the time duration that the auxiliary relay is activated.
 2.2 SECONDS  2 MINUTES 4 MINUTES  8 MINUTES