Risco ProSYS Plus - By Category; One-By-One; Parameters

11
/
2017 Page 104 5IN2413 B
 Parameters
Configure the basic parameters for all zones types by the following method(s):
• One-By-One: Define all the relevant parameters for one zone at a time
• By Category:
Define a specific parameter accordingly for multiple zones
(as you go from one zone to another, scrolling through all zones in the system)
• Resistance:
If required, define the zone’s termination resistance
Note
Advanced parameters are also available for bus zones and wireless zones – see
Step 6: Advanced Zone Configuration for Bus Zones and Wireless Zones, page 68.
One-By-One
Zones  Parameters  One-By-One
Quick keys Parameter Default Range

One-By-One
See Defining Zone Parameters using the “One-By-One” Option, page 65.
By Category
Zones  Parameters  By Category
Quick keys Parameter Default Range

By Category
See Defining Zone Parameters using the “By Category” Option, page 66 for an
explanation, and see below for defining the parameters:
 Label
 Zone Partition (and Group)
 Type
 Sound
 Termination
 Loop Response
 Advanced