Risco ProSYS Plus - Controls

11
/
2017 Page 82 5IN2413 B
 Controls
The Controls sub-menu has the following configurable parameters:
• Basic
• Advanced
• Communication
• EN 30131
• PD6662:2010 (BS 8243:2010)
• CP-01
• Device
System  Controls  Basic
Quick keys Parameter Default Range

Basic Programming
This section refers to the most common controls in the system.
 
Quick Arm
Yes Yes/No
YES: Eliminates the need for a user code when arming (full or partial).
NO: A valid user code is required for arming (full or partial).
 
Quick UO
Yes Yes/No
YES: A user can activate a utility output without the need to enter a user
code.
NO: A user code is required to activate a utility output.
 
Allow Bypass
Yes Yes/No
YES: Permits zone bypassing by authorized system users after entering a
valid user code.
NO: Zone bypassing is not permitted.
 
Quick Bypass
No Yes/No
YES: Eliminates the need for a valid user code when bypassing zones.
NO: Qualified users must enter a valid user code to bypass zones.