Risco ProSYS Plus - Testing the System

11
/
2017 Page 215 5IN2413 B
Testing the System
It is important to fully test the system. Here are typical, recommended system tests
that should be performed at system installation, and subsequently as needed:
 Bus Test: To test bus communication quality. See Performing a Bus Test, page 54.
 Background noise-level threshold & calibration for wireless devices:
See Measuring Background Noise Level and Defining the Threshold Limit, page 69.
 Wireless Communication Test: For testing the signal strength of wireless devices.
See Performing a Wireless Comm. Test for Measuring Signal Strength, page 70.
 Walk Test (for zones): Arm the system, and then enter the protected area in order
to trigger alarm events at each detector to ensure operability. See the installer
Maintenance menu
 Walk test, page 213.
 Monitoring Station Test: See View Menu
 Advanced  MS Test, page 211.
 GSM signal strength (RSSI): View the signal strength result measured by the
GSM module (from 0—5). Go to: installer Maintenance menu
 Diagnostics 
GSM
 Module, page 213.
 Additional tests at the installer Maintenance menu: For keypads, sirens, strobes,
wireless, and diagnostics (including main battery test, and zone resistance test).
See from page 213.
 Follow-Me Test: After programming FM destination(s), go to:
installer Follow Me Menu
 Test. Trigger an alarm activation (for example, as
done during a Walk Test), and see if the FM notification is received at the FM
destination(s). See Follow Me Menu, page 210.