11
2017 Page 180 5IN2413 B
Quick Keys Parameter Default Range
User Initiated Call
Yes Yes/No
YES: For a remote Configuration Software session to take place, the Grand
Master must first enter specific keypad commands in the User Functions
mode.
NO: Configuration Software operations are possible without requiring the
user’s participation.
Communication Configuration SW Gateway
Quick Keys Parameter Default Range
IP Gateway
The IP and port address of the configuration’s software PC. If you have a
router connected to the PC of the Configuration Software, then you should
enter the IP of the router.
This definition will be used when there is a request to create a remote
connection from the panel to the Configuration Software. The connection can
be done over IP or GPRS.
Note
In the configuration software, under Communication Configuration
GPRS , enter the IP address of the PC that the software is installed in.
IP Address
IP Port
Communication Configuration SW Modem Protocol
Quick Keys Parameter Default Range
Modem Protocol
The protocol of the router (modem) connected to the PC of the Configuration
Software. This protocol will be used when there is a request to create a remote
connection from the panel to the Configuration Software.
V21
BELL103
To Next Page
Loading...
