Risco ProSYS Plus - Page 194

11
/
2017 Page 194 5IN2413 B
Install  Bus Devices  Manual
Quick Keys Parameter Default Range

Manual
Use this option to manually add or remove bus devices and set
parameters.
Notes
• Make sure that the bus device’s physical ID number has been "dip
switch" programmed
• Non-partitioned systems are regarded as Partition 1.
• In partitioned systems, keypads can be selectively assigned to specific
partitions
 
Keypads (wired)
See Manually Allocating & Configuring other Modules and Bus Devices 
Wired Keypads, page 57.
 
Zone Expander
See Manually Allocating & Configuring other Modules and Bus Devices 
Zone Expanders, page 58.
 
Utility Output
See Manually Allocating & Configuring other Modules and Bus Devices 
Utility Output Modules, page 58.
 
Power Supply
See Manually Allocating & Configuring other Modules and Bus Devices 
Power Supply Modules, page 59.
 
Wireless Expander
See Manually Allocating & Configuring other Modules and Bus Devices 
Wireless Expanders, page 59.
 
Proximity Key Reader
See Manually Allocating & Configuring other Modules and Bus Devices 
Proximity Key Readers, page 59.
 
Voice Module
See Manually Allocating & Configuring other Modules and Bus Devices 
Voice Module, page 60.