Risco ProSYS Plus - Page 207

11
/
2017 Page 207 5IN2413 B
Devices  Power Supply
Quick Keys Parameter Default Range

Masking
To designate which partition will or will not be operated at the keypad:
1) Press OK ( ), scroll to select the power supply index number,
and then press OK.
2) Scroll to
MASKING, and then press OK.
3) Scroll through each block of partitions (32 partitions maximum—
all enabled by default), and designate the partitions to mask (to
not allow operation via the keypad) by entering a partition
number to delete it (it will not display), or enter the number again
to select it (it will display).
4) When finished, press OK.

Control
To enable/disable the bell/loudspeaker for the power supply module:
1) Press OK, scroll to select the power supply index number,
and then press OK.
2) Scroll to CONTROL, and then press OK.
3) Toggle between Y (yes) or N (no) for enabling or disabling the
power bell/loudspeaker, and then press OK.