Rohde & Schwarz RTB2004 - Page 321

Fernsteuerbefehle
R&S
®
RTB2000
321Bedienhandbuch 1333.1611.03 ─ 05
15.6.4.9 Suchergebnisse
SEARch:RESult:BCOunt?...............................................................................................321
SEARch:RESDiagram:SHOW......................................................................................... 321
SEARch:RESult:ALL?.....................................................................................................321
SEARch:RESult<n>?......................................................................................................322
SEARch:RCOunt?..........................................................................................................322
EXPort:SEARch:NAME...................................................................................................322
EXPort:SEARch:SAVE....................................................................................................323
SEARch:RESult:BCOunt?
Returns the maximum number of search results, which the instrument can store.
Rückgabewerte:
<BufferedCount> Maximum number of search results
Verwendung: Nur Abfrage
SEARch:RESDiagram:SHOW <ResultShow>
Shows or hides the table of search results.
Parameter:
<ResultShow> ON | OFF
*RST: OFF
Beispiel: Kapitel 15.2.3.1, "Puls mit angegebener Breite suchen",
auf Seite 271
SEARch:RESult:ALL?
Returns all result values of the search.
Rückgabewerte:
<AllResults> List of results items seperated by comma
For each result, six values are returned:
1. Result number as indicated in the search results table
2. X-position (time) of the search result
3. Y-position of the search result, currently not relevant
4. Type of the search result (Edge, Peak, ...)
5. Slope or polarity of the search result
6. For peak searches, the value contains the peak voltage. For
width searches, it contains the pulse width. For edge searches,
the value is not relevant.
Messkurvenanalyse