Reference Modification no.
- 0 -
Page
192
Date
1997 02 01
Main
914 F
01479
Reconnect the two oil lines for turbo charger on the oil pump. See chapter
13.2.
◆ NOTE: If location of oil line connections on turbo does not corre-
spond with oil pump housing, correction can be achieved by
slight turning of the turbo centre section p.
Fitting of the 4 exhaust bends [.
◆ NOTE: To make fitting easier Loctite Anti Seize can be applied on
the labyrinth end ].
The connecting ends A of the exhaust bends must overlap the pleat of the
labyrinth by at least 5 mm (0.2 "). See Pic. 152.
■ ATTENTION: All 4 exhaust bends must be fitted free of stress and must not
be damaged at installation.
After completion of installation all the screw connections at turbo charger
bracket, exhaust manifold, exhaust bends and clamp have to be tightened to
the specified torque.
Tightening torque:
hex. hd. screw Q M8x16 Turbo charger bracket 25 Nm / 220 in.lb
Allen screws { M8x25 Exhaust manifold 25 Nm / 220 in.lb
hex. hd. screw i M10 Clamp 20 Nm / 177 in.lb
hex. nuts S M8 Exhaust socket flange 12 Nm / 106 in.lb
At tightening of the exhaust bend flanges ensure equal distance between
flange and cylinder head from top to bottom. See
Pic. 153.
■ ATTENTION: In the high temperature zone of
turbo charger and exhaust system
use exclusively high grade, stain-
less steel screws.
To Next Page
Loading...
