S-COM 7K - Command: Select Pause (B) Digit Time

Telephone Interface Functions
7-11
Select Pause (“B”) Digit Time
Programs the amount the Pause Digit in a phone number delays.
• When the user dials a telephone number or a macro is programmed to dial
a telephone number, a pause digit (the DTMF character “B”) provides a
programmable delay (see page 7-3 for use).
• Enter 1, 2, or 3 digits representing the desired time of the pause in tenths of
seconds.
• The range of the time is 0.1 second to 10.0 seconds.
Command Form:
Command Form Data Digit
Select Pause (“B”) Digit Time (PW) 49 96 xxx * (001-100 in sst –
seconds and tenths)
= (00.1-10.0) seconds
Acknowledgment: Sends OK
Errors:
Error Meaning
? err 1 wrong number of digits entered
? err 2 illegal digit entered
Default Condition: 5 seconds.
Example:
To set the pause digit to 2 seconds, enter the following:
(PW) 49 96 20 *
Note: See Page 7-3, for instructions on using the pause digit when dialing.