Remote Base Interface
21-3
Event Triggered Macros
The system owner must create two macros that are triggered by user function
access to the remote base interface. These Event-Triggered Macros allow the
users to enter simple user function commands to access the remote base to
make use of it, and to dump the remote base when they are done with it.
Below are the recommended macros to use for this function. They can be
modified or enhanced as necessary.
Define a Remote Base Access-Triggered Macro to allow a user to access the
remote base interface. This macro is invoked automatically by the User
Function: Access Remote Base command. This macro enables the link paths
from the repeater receiver and transmitter and the remote base receiver and
transmitter. In addition, a message is sent to the user as an acknowledgment
that the remote base is now available.
(PW) 20 9000 (PW) 63 82 1 * ;Enable Path 2 (RX2 to TX1)
(PW) 29 9000 (PW) 63 84 1 * ;Enable Path 4 (RX1 to TX2)
;Send “Remote Up” Tones
(PW) 29 9000 (PW) 15 9910 54 48 49 50 *
Assign this macro to the Remote Base Access-Triggered Macro by entering the
following command:
(PW) 26 91 9000 *
Define a Remote Base Dump-Triggered Macro to allow a user to terminate
access to the remote base interface. This macro is invoked automatically by
the User Function: Dump Remote Base command. This macro disables the
link paths between the repeater receiver and transmitter and the remote base
receiver and transmitter. In addition, a message is sent to the user as an
acknowledgment that the remote base is no longer available.
(PW) 20 9001 (PW) 63 82 0 * ;Disable RX2 to TX1
(PW) 29 9001 (PW) 63 84 0 * ;Disable RX1 to TX2
; Send “Remote Down” Tones
(PW) 29 9001 (PW) 15 9910 54 50 49 48 *
Assign this macro to the Remote Base Dump-Triggered Macro by entering the
following command:
(PW) 26 90 9001 *
To Next Page
Loading...