DTMF Decoder
11-9
Enable/Disable DTMF Decoder Mute
Turns ON or OFF DTMF muting between any receiver and
transmitter pair.
• Enter one digit, 0 for OFF (disabled), 1 for ON (enabled).
Command Form:
Command Form Data Digit
Enable/Disable RX1-TX1 DTMF Mute (PW) 63 50 x * 0 = OFF (disabled)
1 = ON (enabled)
Enable/Disable RX2-TX1 DTMF Mute (PW) 63 51 x * 0 = OFF (disabled)
1 = ON (enabled)
Enable/Disable RX3-TX1 DTMF Mute (PW) 63 52 x * 0 = OFF (disabled)
1 = ON (enabled)
Enable/Disable RX1-TX2 DTMF Mute (PW) 63 53 x * 0 = OFF (disabled)
1 = ON (enabled)
Enable/Disable RX2-TX2 DTMF Mute (PW) 63 54 x * 0 = OFF (disabled)
1 = ON (enabled)
Enable/Disable RX3-TX2 DTMF Mute (PW) 63 55 x * 0 = OFF (disabled)
1 = ON (enabled)
Acknowledgment: Sends OK
Errors:
Error Meaning
? err 1 wrong number of digits entered
? err 2 illegal digit entered
Default Condition: All DTMF Decoder Mutes are ON (enabled)
Examples:
DTMF Muting is usually left ON (enabled) to prevent annoying DTMF digits
from being repeated, and to prevent listeners from learning command codes.
If it becomes necessary to signal some device that is monitoring Transmitter 1
or 2, you may turn OFF the muting associated with the desired receiver(s) and
transmitter(s).
To Next Page
Loading...