Macros
6-13
Rename Macro
Changes the name of an existing macro.
• The digits (contents) stored under the macro’s name are not affected.
• The macro names (old and new) must be entered using 4 digits.
• If either (or both) is shorter than 4 digits, enter leading zeroes.
Command Form:
Command Form
Rename Macro (PW) 27 (old name, new name) *
Acknowledgment: Sends OK
Errors:
Error Meaning
? err 1 wrong number of digits entered
? not found old name does not exist in the directory
? name used new name already exists in the directory
Default: None
Examples:
Assume that a macro exists under the name 6A, and that we wish to change its
name to 1000. Enter the following command:
(PW) 27 006A 1000 *
Note: A macro name of 1000 would cause a conflict if the autopatch password
were left at its default value of 10. Be sure to select your macro names and
passwords carefully.
To Next Page
Loading...