S-COM 7K - Access Autopatch (With Password)

Telephone Interface Functions
7-29
Access Autopatch (With Password)
Accesses the autopatch using the password method.
• Enter the Autopatch Access Password, followed by the telephone number,
and the star (*), if required. All digits are entered in a continuous string.
• Entering only the autopatch access password will not result in a dial tone.
• The autopatch access password may be any 2,4 or 6 digits.
• The phone number may be up to 35 digits in length, and may contain
special command digits (A, B, C, D).
• See the Change Autopatch Access Password on page 7-32 if you wish to
change the password.
Command Form:
Command Form
Access Autopatch (With Password) (autopatch access password) (phone number)
*
Acknowledgment: Sends the Autopatch Dialing Message
Errors:
Error Meaning
OFF autopatch is OFF (disabled)
? REJ rejected (number in Rejected Number Table)
? ERR rejected (number not allowed by AP Call Type)
BZ phone line is busy (Model 7K controller only)
Default Condition: Autopatch Access Password is set to 10.
Examples:
Assume that the autopatch access password is 10, and that the number you
wish to dial is 456-7890. To access the autopatch, enter:
10 4567890
When the above number is entered the controller will screen the telephone
number. (See the Autopatch Call Types and Autopatch Restrictions sections on
page 7-35 and 7-38 respectively.) If the number is acceptable, the controller
will send the autopatch dialing message and dial the number. If the number is
not acceptable, the controller will send one of the error messages listed above.