Scheduler
9-7
Enable/Disable Scheduler
Allows the Scheduler to process scheduled events (setpoints).
• Enter this command to control if the Scheduler is allowed to process the
programmed scheduled events (setpoints).
• Enter one digit, 0 for OFF (disabled), 1 for ON (enabled).
Command Form:
Command Form Data Digits
Enable/Disable Scheduler (PW) 63 15 x * 0 = OFF (disabled)
1 = ON (enabled)
Acknowledgment: Sends OK
Errors:
Error Meaning
? err 1 wrong number of digits entered
? err 2 illegal digit entered
Default Condition: Enabled.
Example:
To disable the scheduler, enter the following:
(PW) 63 15 0 *
To enable the scheduler, enter the following:
(PW) 63 15 1 *
To Next Page
Loading...