Remote Base Interface
21-19
User Function: Select Transmitter Offset
Selects a transmitter offset on the currently active remote base
radio.
• Transmitter offsets of minus, simplex, plus, and special can be selected.
• This command has no effect when a memory channel is currently selected.
• If the remote base radio transmitter is disabled, it will be enabled.
Command Form:
Command Form
Select Transmitter Offset (RBPW) 42 (offset) *
offset =
1 = Minus
2 = Simplex
3 = Plus
0 = Special: On 1200, Minus 20; On 420-
440, special offset subject to limitations
of radio in use.
Macro: Select Transmitter Offset
(Stored until (RBPW) 39 sent.)
(RBPW) 22 (offset) *
Acknowledgment: Sends OK
Errors:
Error Meaning
OFF remote base is disabled
? err 1 wrong number of digits entered
? err 2 illegal digit entered
Default Condition: The remote base interface is initially off.
Example:
To enable the transmitter and set the transmitter offset on the currently
selected radio to minus, enter the following:
(RBPW) 42 1 *
To enable the transmitter and set the transmitter offset on the currently
selected radio to simplex, enter the following:
(RBPW) 42 2 *
To Next Page
Loading...