S-COM 7K - Select (Review) Initial and Normal ID Tail Messages

7K • Chapter 12
12-10
Select (Review) Initial and Normal ID
Tail Messages
Defines the Initial and Normal ID Tail Messages for Tx1.
• Tail Messages are short CW or programmable messages that can be
appended to an ID message.
• The Tail Number (Data Digit “x”) can be 1 or 2 digits selected from the
following table.
• Enter the command with no Tail Number to disable the Tail Message.
Command Form:
Command Form Data Digit
Select Initial ID Tail Message for TX1 (PW) 50 0 xx * Tail Message
Table (below)
Select Normal ID Tail Message for TX1 (PW) 50 1 xx * Tail Message
Table (below)
Review Initial ID Tail Message for TX1 (PW) 50 0 99 * none
Review Normal ID Tail Message for TX1 (PW) 50 1 99 * none
Data Digit Message Data Digit Message Data Digit Message
0 (no message) 6 WX in CW 12 /R in CW
1 FEST in CW 7 ALERT in CW 13 LINK in CW
2 DUES in CW 8 WATCH in CW 14 RMT in CW
3 MEET in CW 9 WARN in CW 15 BAT in CW
4 NET in CW 10 RACES in CW 98 (programmable)
5 HI in CW 11 TGIF in CW (none) (no message)
Acknowledgment: Sends OK
Errors:
Error Meaning
? err 1 wrong number of digits entered
? err 2 illegal digit entered
Default Condition: Both Initial and Normal ID Tail Messages default to none.
Example:
To select NET in CW as an Initial ID Tail Message for TX1, enter the
command:
(PW) 5004*