Repeater Functions
18-11
Select Repeater Action-Triggered Macros
Allows the programmer to execute macros based on repeater
activity.
• Macros can be executed based on receiver activity, receiver inactivity and
when a courtesy message is sent.
• Enter the password, the 4-digit root number, and the 4-digit name of the
macro you wish to have executed at the transition, and the (*).
• If the macro name has fewer than 4 digits, enter leading zeros.
• If you wish to prevent a macro from being executed that was previously
assigned, enter just the password, the 4-digit root number, and the (*).
Command Form:
Command Form
Assign Macro to Any-Receiver-Active (PW) 26 11 (macro name) *
Assign Macro to All-Receivers-Inactive (PW) 26 09 (macro name) *
Assign Macro to Courtesy Message (PW) 26 10 (macro name) *
Assign Macro to Dropout Message (PW) 26 08 (macro name) *
Assign Macro to Repeater Timeout (PW) 26 18 (macro name) *
Assign Macro to Return-From-Repeater-
Timeout
(PW) 26 19 (macro name) *
Acknowledgment: Sends OK
Errors:
Error Meaning
? err 1 wrong number of digits entered
? err 2 illegal digit entered
Default Condition: No macros assigned.
To Next Page
Loading...