Receiver Functions
16-1
Chapter 16
Receiver
Functions
The commands in this chapter relate to the three receiver ports.
Each receiver has access to either or both transmitters, if enabled (see the
Links chapter on page 13-1). Each receiver has access to the DTMF decoder,
if enabled (see the DTMF Decoder chapter on page 11-1).
The usual configuration has Receiver 1 as the repeater receiver, and Receivers
2 and 3 as link receivers. Or, Receiver 3 might be a control receiver with priority
access to the DTMF decoder. The final configuration is up to the programmer.
To Next Page
Loading...