Programming Tables
A-27
Messages by Number
Program with (PW) 31 (number) (message) *
Review with (PW) 34 (number) *
Page Number Description Default
4-45 00 Warm Reset Message ?RES in CW
4-44 01 OK Command Response Message OK in CW
4-44 02 Error 1 Command Response Message
?ERR1 in CW
4-44 03 Error 2 Command Response Message
?ERR2 in CW
18-9 10 Courtesy Message for Rx1 60 mS
440 Hz
(74 09)
18-9 11 Courtesy Message for Rx2 60 mS
660 Hz
(74 16)
18-9 12 Courtesy Message for Rx3 60 mS
880 Hz
(74 21)
4-37 13 Dropout Message none
4-37 16 Pre-Timeout Message TO in CW
4-37 19 Post-Timeout Message TO in CW
12-9 28 Initial ID Programmable Tail Message for Tx1 none
12-9 29 Normal ID Programmable Tail Message for Tx1 none
12-3 30 Initial ID Message for Tx1 ID in CW
12-3 31 Normal ID Message for Tx1 ID in CW
12-3 32 Impolite ID Message for Tx1 none
12-3 33 Initial ID Message for Tx2 9983 ID in
CW
12-3 34 Normal ID Message for Tx2 9983 ID in
CW
12-3 35 Impolite ID Message for Tx2 none
7-7 40 Autopatch Dialing Message AS in CW
7-27 41 Autopatch Timeout Warning Message AR in CW
7-8 42 Landline Busy Message BZ in CW
7-9 43 Autopatch Dump Message none
7-8 44 Autopatch Off Message OFF in CW
7-8 45 Autopatch Error Message
(Invalid phone number)
?ERR
in CW
7-8 46 Autopatch Reject Message
(Match in Reject Table)
?REJ
in CW
7-8 47 Autopatch No-Redial-Number Message CLR in CW
7-54 50 Phone Line Answer Message 3 beeps
(74 09 21 33)
7-62 51 Reverse Patch Ringout Message 55 in CW
To Next Page
Loading...
Need help?
General