Identifier
12-3
Select (Review) Identifier Messages
Define the Initial ID, Normal ID, and Impolite ID Messages for Tx1
and Tx2.
• Any message may be a combination of message types including CW,
beeps, page tones, speech, etc.
• The maximum size of any message is 50 bytes (50 2-digit codes). You
must count the control characters. Therefore, any message could have 46
CW characters, 23 synthesized speech words, etc.
• To delete a message, enter the password, the 4-digit root number, and the
(*); do not enter any message.
• If an Impolite ID Message is not programmed, the Normal ID message is
sent.
Command Form:
Command Form Default
Select Initial ID Message for TX1 (PW) 31 30 (message) * ID in CW
Select Normal ID Message for TX1 (PW) 31 31 (message) * ID in CW
Select Impolite ID Message for TX1 (PW) 31 32 (message) * none
Select Initial ID Message for TX2 (PW) 31 33 (message) * 9983 ID in CW
Select Normal ID Message for TX2 (PW) 31 34 (message) * 9983 ID in CW
Select Impolite ID Message for TX2 (PW) 31 35 (message) * none
Review Initial ID Message for TX1 (PW) 34 30 * none
Review Normal ID Message for TX1 (PW) 34 31 * none
Review Impolite ID Message for TX1 (PW) 34 32 * none
Review Initial ID Message for TX2 (PW) 34 33 * none
Review Normal ID Message for TX2 (PW) 34 34 * none
Review Impolite ID Message for TX2 (PW) 34 35 * none
Acknowledgment: Sends OK
Errors:
Error Meaning
? err 1 wrong number of digits entered
? err 2 illegal digit entered
Default Condition: TX1 is ID, TX2 is 9983 ID, both in CW.
Note: Be sure to enter a routing code for messages to TX2 or the message will
go to TX1 instead.
To Next Page
Loading...